Burin engraving?
 

Burin engraving?
help to identify and assess the subject

size approx. 15,5*23.5 cm thickness approx 2.5mm

It is rather a cliché from which engravings of. With HC.

[QUOTE=Николаич;3305121]Rather-it's a cliche,from which the engravings of. With UV@

Well let it be cliche.
I wonder how much it costs?
can where were passages such items?

I think nothing will cost...
Copperplate has numerous traces of corrosion. Means on the impression will be numerous spots-defects. In addition to artists, printing etchings this subject hardly anyone will be interested.
To pass in the acceptance of metal is not necessary. It is better to refer to the temple.
Sincerely,

[QUOTE="Пряник;3305731"]Rent or acceptance of metal is not necessary. It is better to include in HRM@
Properly, pop himself torn down.

Not be demolished. And read a special prayer and somehow destroy the image of the virgin.
Paper, wooden icons burn.
Even if You do not believe, then perhaps you can be considerate and respectful and don't use any case for kicking this moment You do not understand.
Believe me, to see the face of hosts first in a "situation", and only then to know him on an icon worth it...
With sincere respect for Your knowledge,

Advise to show the Board the painter-etcher, he will tell you what to do. In my opinion, you can polirnut', to make a test print and then to deepen those strokes that are poorly printed. On copper plates the prints were made by the cutter, zinc, by etching, the etching. In the printing process of the circulation of the edge lines flattened (especially on copper plates), it undermined the quality of the print, then the artist was armed with a cutter and was corrected (deepened) became weak line. Note that the boards, which were printed engravings, prized by fans of engravings and often they are going. Sometimes the boards are cut, and to avoid the "left" (neavtorskom) runs, and then the owner of the sheet is given a small piece of Board -- as a confirmation of the authenticity belonging to the imprint.