Restoration Kasli
 

Good day to all!
Prompt people know to be a figure Kasli old restoration.
The horse broken leg (fractured at thinnest point) whether it is possible welding, brazing, or some other method.

I know that molding restored.

meison, most other methods, but this methodology is not perfect, by museum standards, and does - doubtful. Briefly: ream both sides under the pin , put the pin joints and loss of mask epoxy resin grind frozen , do toning acrylic. The same theme runs at medium-sized losses, can be cast on and cast viksinte piece of gum. Cast even on an ordinary plasticine can be done , but it only works when a person has hands of gold.

As far as I know , welding and soldering are possible , but there are some limitations , the theme is not mine, not focusing .

A necessary condition for any restorer!

 If only part of the sculpture is broken , the adhesive paste ( the so-called cold welding ) or other good adhesive ... And if otrachena , then cast the missing piece and glued again .. This is what I know to restore Kasli .. Perhaps there is other ways .

meison, laser welding, pulsed, followed by treatment with sutures.
It's okay if you do.
From SW.


http://rutube.ru/tracks/3964874.htm

http://www.youtube.com/watch?v=UykpjaNUsIw

Sounds nice, but in the video presented at the exhibition show the sample , and where feasible and in what company or institution in which people will be able to find such a setup ? ? So if you can weld and solder sormaytom or autogenous soldering copper ... But what it will look like ...???

Check it out here :
http://www.antik-forum.ru/forum/showthread.php?t=3958

Have to call and find out.
For example, in St. Petersburg:
New dates of the 15th International Exhibition "Welding" .
The 15th International Exhibition for welding, cutting and related technologies "Welding -2012 " will be held May 15-18 , 2012, pav.7 , 8A , and 8 " Fairgrounds ." You can slip the guys at the show , ts "to demonstrate ." :)>

It's complicated. Can easily give to the work of spices ? :)>

 
I agree ... Not knowing the technology and methods of restoration of metal easier to give the spices ... and it will probably be the only correct decision.